|
|
 When should the Cold Forming process be considered? The part has multiple diameters High production quantities of the appliedextrusiontechnology part are needed Significant raw material costs are associated with the part Part strength and reliability are important manufacturing criteria The Value of Cold Forming: Because appliedextrusiontechnology raw materials are often times the most expensive component of manufacturing a part, Cold Forming is a low-cost alternative Cold Forming appliedextrusiontechnology and appliedextrusiontechnology capabilities often reduce part costs while improving part quality and productivity. Generally the wire is feed into the forming machine by means of feed rolls, cropped to length by a shearing action then progressively cold formed. During the cold forming process, un-heated parts are forced into die cavities by forming punches to achieve a desired configuration, the friction between the forming tools and the material being formed results in an increase in temperature of the work-piece resulting in a work hardening appliedextrusiontechnology effect. Spinning, radial riveting, spin riveting and peening are terms often used to refer to orbitforming, a cold-forming process that uses an orbiting tool to swage, head, crown, flare, or form a column or projection of malleable material for the purpose of fastening in assembly operations. The process is similar to impact and compression forming, where the tool applies a compressive axial load to permanently deform the part, according a designer, appliedextrusiontechnology manufacturer, and integrator of forming, fastening and assembly appliedextrusiontechnology systems The difference appliedextrusiontechnology is that in orbital, the tool rotates at a fixed angle-typically 3 to 6 degrees-and applies both axial and radial forces to progressively move malleable material into a desired, predetermined shape. Unlike impact or compression forming, where the process is completed in a single pass, forming requires several tool revolutions and typically takes appliedextrusiontechnology 1.5 to 3 seconds to complete. Additionally, most of the work during orbital is at the tool''s line of contact, not along the entire tool surface. The resulting small-contact area reduces axial loads by as much as 80 percent. We are the ultimate online resource for many different metal working jobs. We have the most knowledgeable employees and the best equipment available so we can get the job done right.
|